Its a Bug in Configurator 8.0.1? Manual Mode never end

[ThomasCr]

Hi,

yesterday I updated my INAV setup from 6 to 8 and could not set up Manual mode, because it newer leaves the manual mode.
I cant check what the mode on the controller really is, because i dont have FPV/OSD.

Is it known or should I open a bug report?

I use MATEK F405-WSE (F405SE Target) with INAV (Configurator) 8.0.1 on Linux

2025-06-29.09-37-35.mp4

[MrD-RC]

Calibrate your accelerometer.

[ThomasCr]

ok, I did so yesterday - does it mean something in the calibration task was wrong?

I dont think so, because on the second Airplane I have this problem too (with the same remote).

But after I switch the remote it is was possible to setup. And both remotes are Graupner with HOTT (MX-12 + MX-16)

[x3lor]

I had the same issue a few days ago. But is was only a display issue in the configurator. When Manual is disabled the Acro-Mode gets active.