CLITool support for Firmware NCS314 HW v3.x

[ironcastlesystems]

When trying to use the CLITool utility with firmware NCS314 HW v3.x, and the Raspberry Pi Astrpa v.2.1, it does not display correctly. For example, entering 'CLITool 123456' displays '726594' on the tubes. Are there plans to update the utility so that it can be used with the updated firmware?

[RedneckJP007]

When trying to use the CLITool utility with firmware NCS314 HW v3.x, and the Raspberry Pi Astrpa v.2.1, it does not display correctly. For example, entering 'CLITool 123456' displays '726594' on the tubes. Are there plans to update the utility so that it can be used with the updated firmware?

I'm in the same boat with the CLITool doesn't seem to work with HW version 3 boards yet, i was able to get the firmware for v3 to kinda work with my v3 board by remaking the "make file" but for some reason it didn't seam like i had all the features of the firmware like my 3 buttons only controlled the time and that was it i couldn't change it to a 12HR setting with any command at launch or button combination.

[afch]

Hello. Our Raspberry Pi configuration Clocks support only the basic time display feature. All other functions that are made for our Arduino Clocks you will need to do by yourself. пт, 23 февр. 2024 г. в 07:45, RedneckJP007 ***@***.***>:

…

When trying to use the CLITool utility with firmware NCS314 HW v3.x, and the Raspberry Pi Astrpa v.2.1, it does not display correctly. For example, entering 'CLITool 123456' displays '726594' on the tubes. Are there plans to update the utility so that it can be used with the updated firmware? I'm in the same boat with the CLITool doesn't seem to work with HW version 3 boards yet, i was able to get the firmware for v3 to kinda work with my v3 board by remaking the "make file" but for some reason it didn't seam like i had all the features of the firmware like my 3 buttons only controlled the time and that was it i couldn't change it to a 12HR setting with any command at launch or button combination. — Reply to this email directly, view it on GitHub <#5 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AAROBMT4SSSB7ZF6FHWGKX3YVAUHHAVCNFSM6AAAAAA6X7HQSGVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMYTSNRQG43DENZZGY> . You are receiving this because you are subscribed to this thread.Message ID: ***@***.***>

-- Alexey [GRA & AFCH]