M3Y-W Scanner does not work per default

[Schnuartz]

If you connect the M3Y-W Scanner with the Barcode Scanner Module Board it doesn't work intitially.

For the GM65 Scanner you need to enable the "USB Virtual Serial Port". This is easy easy as the GM65S Scanner initially starts scanning.

The right mode equivialant mode for the "USB Virtual Serial Port" to use this programm is is the "USB-CDC" the QR Code can be found in the UserGuide.pdf at 2.3 page 13.

Here is the QR Code to activate this mode:

[Schnuartz]

Currently this is how I'm reprogramming the M3Y Scanner.
This is another version of the QR Code I shared earlier. But neverthe less this is how I'm doing it: